Limit switch actuator mounting instructions
1. Remove the screw attaching the nylon rack to the angle that is closest to the position of the reed switch on the motor when the gate is in the close and open position.
2. Fit limit switch actuators with screws provided onto the nylon rack.
3. Setting the gate close actuator
– Close the gate with approximately 15-20mm gap between gate and close stopper. Now move the actuator until the close LED lights up. Fasten the actuator.
4. Setting the gate open actuator
– Open the gate with approximately 15-20mm gap between gate and open stopper. Now move the actuator until the open LED lights up. Fasten the actuator.
5. The gate must never bump against the close or open end stoppers.
Important:
For safety reasons, a solid stop must be fitted at both ends of the gate to prevent the gate from moving past its full op en or close position.